Learn more about building a DIY conservatory from the experts.
Fix into position with two 16mm self-drill screws per side. Fig 3
Lay the sill in position, the inside of the sill to the inside of the outer brick on the base or the outer skin of the dwarf wall. Fig. 4
Check for square by measuring the diagonals inbetween the two sill sections where they meet the wall and the first joint, and for parallel. fig. 5
First installment of building your DIY conservatory ...
Please check that the base and dwarf walls have been constructed (and are level) according to the base / dwarf wall plan issued for your conservatory (contact us on 0800 161 3034 if you need more information). Lay out the sill components in the formation required, (allowing for the required positioning of the French Door dwarf wall). fig 1 
Silicon seal the complete edge of the sill and join each section together with the aluminium sill angles and sill connectors, ensuring that the joint is held in the correct position. fig 2
Over the next few weeks we will be uploading extracts from our installation guides to help you plan the installation of a DIY conservatory - and to try and show that it isn't as hard as it looks!
Today a few words in preparation:
Note ... Always read the COMPLETE instructions fully before you start constructing, as knowledge of the latter stages of the build should explain the instructions at the start. These blog posts are not intended to replace complete instructions, just act as a guide. Contact us now on 0800 161 3034 if you need more information
- All instructions are viewed from OUTSIDE and are taken from LEFT to Right.
- Please use a QUALITY low modulus silicon sealant. Use sparingly in all applications and areas as instructed
- Remove any render, pebbledash or aesthetic coatings etc. The panels and roof must be fitted to sound clean walls.
- All panels are externally glazed and MUST be fitted with the beads to the outside. The French Doors are outward opening,
with the master door on the left.
- When fitting the frames please ensure that you fit with the drainage slots to the BOTTOM.
- When fitting any panel or component, please use a long spirit level to ensure that it is PLUMB and LEVEL.
- Using 3 clamps per panel, tightly CLAMP all components in place until they are permanently fixed.
- Code 4 lead (inserted to a minimum of 25mm into the parent wall) should be used to seal the conservatory.
With all the talk about house prices - are they going up or down or, heaven forbid, staying the same - we think that it's easiest to stay put and think about extending what you've got instead.
So you could build an extension ... but that's expensive, time consuming, needs planning permission and generally involves relying on a builder to deliver you safely to extension nirvana.
DIY conservatories offer an alternative solution that is cheaper, quicker, often doesn't need planning permission ... but can involve getting your hands dirty as you rely on your self to build it! And if you can't rely on yourself, who can you rely on?
This blog will give you all the help and information you need to take on this kind of self build project, and we can even sell you the materials you need. Keep visiting us for updates on the world of DIY conservatories and get ready for more space that even Dr Who knows what to do with!
